![the active directory domain services is currently unavailable remote shutdown the active directory domain services is currently unavailable remote shutdown](https://www.technorms.com/assets/ATIVE-DIR-ERROR.jpg)
- #The active directory domain services is currently unavailable remote shutdown series
- #The active directory domain services is currently unavailable remote shutdown windows
To configure AlwaysOn High availability, we should know some basic knowledge of Windows Server. This may help beginners who are going to configure for the first time.ĪlwaysON is one of the High availability options in SQL Server which is used for a Disaster recovery solution.
#The active directory domain services is currently unavailable remote shutdown series
Finally I was able to logically move the server back to the correct site and everything functioned normally.In this series of AlwaysOn High availability configuration in SQL Server, I am going to write step by step articles from pre-requisite to end configuration. Next I ran the repadmin /replsum command again and saw that successful replication had occurred. After replication finished I noticed that the local DNS server was functioning correctly and that the sysvol and netlogon shares had been created on the server. Once that’s done I again ran the repadmin /kcc * to create the correct site connections followed by repadmin /syncall. So in this case it was as simple as going into AD Sites and Services, choosing move on the domain controller with the issue and putting it in a different site. Essentially if you bring up a domain controller in a site without a fully replicated domain controller already in it replication will continuously fail, but as soon as the domain controller is logically put into a site with a “good” domain controller it will replicate. Dcdiag /test:Connectivity dcdiag over all is great, but using the /test modifier you are able to run only specific tests as neededĪs stated in the introduction, the problem here ended up being one known within the Directory Services support group, but as far as they or I know not documented publicly anywhere.Repadmin /kcc * Forces a recalculation of the topology, has the effect of rebuilding the automatically created partner connections in Sites and Services.
![the active directory domain services is currently unavailable remote shutdown the active directory domain services is currently unavailable remote shutdown](https://blogs.sap.com/wp-content/uploads/2018/08/7-2.png)
Repadmin /replsum Summarizes the state of replication of the forest.Repadmin /syncall /AdePq Performs a synchronization for a server with all of its replication partners, the modifiers help in performing the sync in a multisite environment.Once we got past that provided quite a bit more information. After contacting support I was honestly surprised that this seemed to be a staple of troubleshooting for them as well, because at each tier of support that I worked up this process was done again in total domain dontroller promotion was performed on this 4 times. Before contacting support I took the generic step of trying the process of demoting and then re-promoting the domain controller again with no noticeable effect. Once the problem was as fully defined as possible, both by myself and Microsoft support engineers, the troubleshooting process began. Above and beyond these issues using the portqry.exe tool I was able to figure out that the server was not listening on any of the relevant domain controller ports, TCP 137-139 or UDP port 53.DNS-Server-Service 4013 “The DNS server is waiting for Active Directory Domain Services (AD DS) to signal that the initial synchronization of the directory has been completed.”.ActiveDirectory_Domain_Service 1566 “All directory servers in the following site that can replicate the directory partition over this transport are currently unavailable.”.
![the active directory domain services is currently unavailable remote shutdown the active directory domain services is currently unavailable remote shutdown](https://www.interfacett.com/wp-content/uploads/2013/03/001-dcpromo-exe-utility-demote-domain-controller-in-windows-server-2012-AD-DS.png)